1 files changed, 26 insertions, 16 deletions
diff --git a/mussel5/mussel5.ino b/mussel5/mussel5.ino
index f44c907..12f42d6 100644
--- a/mussel5/mussel5.ino
+++ b/mussel5/mussel5.ino
@@ -1,33 +1,41 @@
-const int buttonPin = 9;    
-const int redLED = 3;
-const int greenLED = 4;
-const int yellowLED = 5;
+/// mussel_mood.ino - Button-controlled LED system with state tracking
+///
+/// SPDX-License-Identifier: GPL-3.0-or-later
+/// SPDX-FileCopyrightText: 2025 Tanishka Suwalka <tanishkas@ruc.dk>
+///
+/// This code toggles LEDs based on button presses, cycling through Red, Green, and Yellow states.
 
-int buttonState = HIGH;   
-int lastButtonState = HIGH;
-int clickCount = 0;
-unsigned long lastDebounceTime = 0;
-const unsigned long debounceDelay = 50;
+const int buttonPin = 9;      
+const int redLED = 3;         
+const int greenLED = 4;       
+const int yellowLED = 5;      
+
+int buttonState = HIGH;       
+int lastButtonState = HIGH;   
+int clickCount = 0;           
+unsigned long lastDebounceTime = 0; 
+const unsigned long debounceDelay = 50; 
 
 void setup() {
-    pinMode(buttonPin, INPUT_PULLUP);
+    pinMode(buttonPin, INPUT_PULLUP); // Enable internal pull-up resistor for button
     pinMode(redLED, OUTPUT);
     pinMode(greenLED, OUTPUT);
     pinMode(yellowLED, OUTPUT);
-    Serial.begin(9600);
+    Serial.begin(9600); // Initialize serial monitor for debugging
 }
 
 void loop() {
-    int reading = digitalRead(buttonPin);
+    int reading = digitalRead(buttonPin); // Read button state
 
-    // Debounce logic
+    // Debounce logic: Ensures a single press isn't detected multiple times
     if (reading != lastButtonState) {
-        lastDebounceTime = millis();
+        lastDebounceTime = millis(); // Reset debounce timer
     }
 
     if ((millis() - lastDebounceTime) > debounceDelay) {
+        // Check for button press (transition from HIGH to LOW)
         if (reading == LOW && lastButtonState == HIGH) {
-            clickCount++;
+            clickCount++; // Increment click count
             if (clickCount > 3) {
                 clickCount = 0; // Reset cycle after 3 clicks
             }
@@ -35,15 +43,17 @@ void loop() {
         }
     }
 
-    lastButtonState = reading;
+    lastButtonState = reading; // Update button state
 }
 
+/// updateLEDs() - Updates LED states based on click count
 void updateLEDs() {
     // Turn off all LEDs first
     digitalWrite(redLED, LOW);
     digitalWrite(greenLED, LOW);
     digitalWrite(yellowLED, LOW);
 
+    // Determine which LED to turn on
     switch (clickCount) {
         case 1:
             digitalWrite(redLED, HIGH);